[attachmentid=107574][attachmentid=107570][attachmentid=107568]
[attachmentid=107572][attachmentid=107575][attachmentid=107576]
Thought i would share these the right way round!

Am waiting on emailed photos!

Poxy NTL!

Thanks

FP

Thats one smart mother fucker!

I notice its indoors and theres a light leak on the doors though, was that just couse you was to stoned to close the door properly or could a bit more DIY be used? Maybe lineing the edges of the doors with a thin rubber or somthing would help. I used old bin bags for my and stapled them there But that was in the shed and didnt really last long..

Cheers,its not finished yet should be sealed this week,also a mesh sreen of sum type to go over the passive intake holes at the bottom!

Thanks

FP

Looking good Frankie! is that 5litre bottles of Ashbeck mountain spring water in there? oh and what's that purple light up the top about?

You've done yersel proud FP, that controller's a bit flash innit.

Yeah like to use the water,until i can afford a RO unit that is,and the purple glow is a mixed (purple) light that clips on to the top of my clone prop!

I have now planted all into 3inch blocks 4 strains so far and waiting on a Jackflash and SSH!

Thanks!

FP

Getting there!

As it happens the controller was about £120 a few years ago and will also control a 2kw heater!

Thanks for the comments,have a small problem with pests at the momment and will have until sealed!

But i have now put in loads of sticky traps and treated feed water with Fugus Gnat Off,have also put 2 traps on top of takaway cartons to trap them!

Thanks

FP

[attachmentid=107803]
The next project!