Good Morning all!

Ok, the problem is as follows, i recently got a new RUCK125L fan/Filter combo and a STR-1-15L22 fan controller from Greens.
I have had a go at wiring it up, and the fan runs, but i get no difference when i turn the Knob on the controller, this leads me to believe i have wired something wrongly!!!
Im sorry, i dont know how to attach a diagram, so i will try to write here as best i can what i have done so far, in the hope that someone could point me in the right direction please?

Ok, I have the pre wired plug, coming into the controller, G+Y to earth,Brown to L, Blue to N.
Cable coming out of controller,blue from N1, Brown from L1, i had the earth in with the 1st earth block, dont think that is right.
(The Chcolate block in the controller reads as follows......Earth--L--N--L1--N1--U--N)

From the controller into the choclate block in the fan--G and Y-Earth,Brown--L,Blue--N

Link to controller info--FAN Controller


If that makes any sense?
Im unsure where the earth out from the controller to the fan goes on the actual controller, i had it in with the earth in, but perhaps that is the problem?

In short, please help!!!!

Many thanks in advance for any help offered.

sorry mucker im not brill with electrics..,im sure scribble or leccy-man or some such techno head will be along forth-with to help..

gwaan il bump ya.....

Thanks anyway mate, i appreciate the sentiments!
Im frustrated that i cant get it going, allthough on the plus side, 3 Diesel Ryders, a sour Cream, and a white widow have poked their heads above ground today, so its not all bad!!!

live and neutral go to L and N respectively, live to fan from U1 neutral to fan connects to N. terminals L1 and N1 is a 240v output that you can connect other bits of equipment that need a full 240v to, that you only want on when the fan controller is on.... i.e. for just your fans, not needed

You, Sir, are an absolute legend, thankyou so much for your time.

yeah i know