Bizzaro's Kingspan Erection., new room for a new grow start. Options

[bizzaro73]

ayup fellow 420'ers..,right as some of ya might know im moving house very soon,this weekend in fact and iv been workin like a twat tryin to get this new grow room built n tested before saturday.

well its been in the process of bein built for about a week now,few hours stolen each day to do a bit more around my usual life shit.

And i would like to add,this wouldnt have been possible to get built in the time i did and with the funds i have available right now if it wasnt for my really good main mucka..,and i know a LOT of folks here know him,LEEPY.. ...
...thanks a fuckin million comrade.,the kingspan alone would have cost me plenty'a dollar!..you are a true gent and i owe ya one for that kind offering.

yeah so this particular kingspan has been used all in the name of canna by our for-mentioned,esteamed member on his previous grow room.
so heres me hopin for some of those good vibes to rub off into my new grows.

right so this loft was floor boarded out alredy,with twosingle power points,one which has been utalised into the grow room its self,can maybe use this for any circ fans/humidifier/de-humidi ect..and use the out side point for my lamp and rvk's.

anyow enough waffle my fingers are goin numb now anyow,so heres some pics..hope ya can make out whats goin on.

this pic just shows the general kinda shape of room,all id done here was plaster board the roof with rockwool roll filling behind.then no nail'ed some of the kingspan to the back wall,ready for the side walls building.


e2a...sorry right side wall already fitted in this pic.

This post has been edited by bizzaro73: Oct 16 2008, 01:34 PM

Attached thumbnail(s)

 

[bizzaro73]

before i put up the kingspan to the end wall i had to squirt some expanding foam into the brickwork as it meets the house roof as you could get a torch and peer right into next doors loft space!!!...not good as obviously they can do the same!!...luckily theres no one living in that house just yet.

so expanda foam it was,let it go off and slice it back nice n neat.

Attached thumbnail(s)

 

[bizzaro73]

ok so this i hope to show ya how i taped the KS panels together with aliminium tape to form one big wall panel,and once again a kind offer from leepy..,cheers bro.

And then how that wall was simply slid into place and taped in position up against the back wall.

Attached thumbnail(s)

 

[bizzaro73]

this just shows how the roof line kinda meets the grow room wall,right hand side wall.And kinda how the plaster board was insulated with rockwool. ...shit you not it was a nightmare trying to push the RW up behind the boards!!...my arms and hands are scarred to buggery coz of the roof slate nails comin thru the timbers.

all in the name of 420 thou eh folks...

Attached thumbnail(s)

 

[_Robert Plant_]

alright dude, looking sweet

how big is the space again mate, (i know youve already told me, stoners memory )

Bob

[bizzaro73]

ok these last lot are a tad random,this n thatso to speak!..BUT this is the in room power point on the end wall.boxed round with KS.


hey hey HEEEY mr Plant ya oreet comrade?......mate the room measures a nice steady 1.8 mtr by 1.8 mtr..got about 5 ft head space,so plenty,i like to keep em medium sized ya get me.

This post has been edited by bizzaro73: Oct 16 2008, 01:49 PM

Attached thumbnail(s)

 

[bizzaro73]

...nice n clean....after the black/white sheeting line out.
and that WAS a pisse to do on mi own!....fuckin staples DONT hold well in plaster board!...note it!...

tryin to hold a big sheet of liner and staple nice n square to the cieling n walls with just two hands was virtualy impossible!!.....i was cussing n swearing n sweating....all good tho naah.

Attached thumbnail(s)

 

[bizzaro73]

this is a shot from just inside the room,kinda showin the roof line shape to the room if ya get me?.

Attached thumbnail(s)

 

[bizzaro73]

this was a tricky shot to try get,from inside the room lookin out.also the grow room door/panel can be seen outside the room.
this too was fashioned from the KS panels,so i can just basicly remove the front wall of the room to gain acsess.this door is about 48in high by about 60inch long.

sorry no it dont my mistake.but it is lookin out/up rather than in

This post has been edited by bizzaro73: Oct 16 2008, 01:59 PM

Attached thumbnail(s)

 

[bizzaro73]

...this one showin the door/panel.

Attached thumbnail(s)

 

[bizzaro73]

one from out to in.

yeh showin how the sheeting comes to meet floor level.
i will be puttin some carpet in on the floor covered by more sheeting,then taped up the walls a good few inches in case of spills ect,nice n easy to clean when needed.

This post has been edited by bizzaro73: Oct 16 2008, 02:06 PM

Attached thumbnail(s)

 

[fresh air inspec...]

I thought the title was Bizaro's Kingsize Erection.........bud porn later then??

I'll get my coat after wishing Biz good luck.....best of with the grow mate, looks a nice room

[bizzaro73]

ok last but by no means least for today,some of the kit to be hooked up at some point tomorow when i can take this tent down im running on weed dry duties right now!!...get that poxy bit jarred up and get this 6 inch insulated ducting down there and fitted..,along with the 6 inch rvk.l1.
as ya can see my 5 inch box insulated rvk is there waiting to be fitted.

oh and yet ANOTHER gift from leepy!......and get this chaps..,only a fooookin REMOTE CONTROL multi speed fuckin airforce circ fan...

sweet as leepy,

Attached thumbnail(s)

 

[bizzaro73]

I thought the title was Bizaro's Kingsize Erection.........bud porn later then??

I'll get my coat after wishing Biz good luck.....best of with the grow mate, looks a nice room

....fresh air duder,long time bro..hope ya just chipper pal?

...yeah and that bizzaro's kingsize watsitt is what r'lass keeps hopin for too!!....

and mate put thatcoat down n chill some eh.

thanks for ur kind words.

[leroy]

lookin good there m8,
you must have been down Leepys hole a lot for all that free gear