Register now to gain access to all of our features. Once registered and logged in, you will be able to contribute to this site by submitting your own content or replying to existing content. You'll be able to customize your profile, receive reputation points as a reward for submitting content, while also communicating with other members via your own private inbox, plus much more!
This message will be removed once you have signed in.
Search the Community: Showing results for tags 'sift'.
Found 3 results
Hello everyone here is a nice video showing some very pure hash made from our automatic cheese that was seeded to create our seed,s but also produced some excellent 90-95% pure heads. This was a relatively gentle bounce on the dry sift screen,s we could have been a lot more aggressive with the material but we wanted the best product with the least amount of contaminates . Enjoy y`all D-M.
Dry-ice (CO2) sift and pressing report. I've been playing about with dry-ice sifting for a year or so, but in small runs. No more - lots of trim, popcorn and entire plants, 5kg of dry ice slabs, a bucket, a 220 micron gauze and a mirror... I ran two grades of product through, the first was dry trim and popcorn bud from a variety of of my stock plants: Northern Lights, Blues, Skunk, etc. The second run was an assortment of Attitude freebies, mostly Snowcap, that I won't be cloning. Using 1,150g of product, I produced 185g of sifted polm, about 155g of it "primo", or first grade, and 30g "secundo". I could have produced more but I usualy call a halt when there is a noticable darkening of the polm. The residue is usually refluxed in iso to give a 10:1 extraction, so I'll expect up to 100g of dark oil from this too. I've experimented with pressing the sift with varying results, and several iterations of press and mould later I've built a 10-ton hydraulic press and a stainless steel mould (10mm press plate in a 5mm wall mould) that doesn't buckle under pressure. (The stainless steel bit is important to me because I process med-grade). I've had good result at about 4 tons pressure with a one-inch square mould (before it warped), but 9 metric tons on a 9cmx9cm plate equals about... enough. Some primo grade sift was too sticky to push intact from the mould - I rolled some up into a fat tola. Most formed very flexible slabs whether 2 or 10mm thick.. The lower grade "secundo" made a lovely solid passport slate. Pictures attached: The tolas are sticky primo (Attitude freeby selection), the big and four small squares are another primo (from the NL/skunk trim) and the lighter thin rectangular slab is the secundo. All good stuff.