Ok, the new problem... My PH is a bit low for my feed. So that is going to be adjusted. However, for those who asked in a previous thread what the PH and EC were, well I splashed out and bought myself a crissy prezzie of an EC and PH meter, they arrived today. I have tried el-cheap-o route, splashed out on a couple of middle of the range meters that were about the £35 mark each. Normally about £99 the pair, got then on deal via a trader that I have used several times for substantial purchases and got them both for £69.99. So these are not your £20 grow shop cheap as chips, ok for a grow meters. The PH meter was easy to set up, there is an option to set the alternative end standards of 4.0 and 10.0 on the PH scale, I just went with the Neutral PH 7 standard for now. The EC meter was pretty much same sort of deal, I happened to have bought, quite by accident a month or so back, EC28 buffer... Single button push calibration... Couldn't ask for more. OK now, those people asking what my water EC and PH is. This is a current state that IS GOING TO BE CORRECTED. Feed mix... PH 4.3 EC 1.3 Separate Water (for all uses, including adding more water to the pot when dry between feeds) PH 4.8 (Originally I set the PH to 7 for a baseline, was aiming for PH5 when PH was too high) EC 1.0 The water I used to water and other things like spraying was aimed at being PH 5 as I needed to drop the PH of the water in the pot as it was a bit high, the test paper system I used was pretty good guide and PH had risen to above 7. So now I can make the required changes to the current feed mix, readjust the water back to PH of 7.